Take advantage of this cut to clean out the viscera so all that is left is meat. To make this easier first make a cut from the neck right down the body to the tail. The hardest part is skinning the lizard as its skin is very well stuck to the body and will need a lot of pull strength. Then we cut off its clawed feet and the end of the tail, thought this is not an easy task without a well sharpened knife. First we have to chop the lizard’s neck with a machete. The cleaning phase will be better carried out near water, at the edge of the sea or by a stream. A strong hand on the neck and another on the tail will be sufficient. Also the lizard will use its tail like a whip so this has to be restrained as well. Well really these animals are very easy to manage but we have to be careful not to let ourselves be bitten as the wound will instantly become infected. The question we ask ourselves when we find a lizard caught in the trap by its leg is how on earth do we grab it with our hands. If the fish/bait were fresh on the first day then it could take around 48 hours, which is what happened to me on the video. As we mentioned before, the stronger the smell more chances there are to attract the lizard. The time it can take to trap our prey will depend on the number of lizards on the desert island and also on the grade of decay of the bait. Once the traps and bait are ready we’ll have to wait well away from the scene for at least the first 12 hours. On the video, I used a piece of old bamboo. We can us something as simple as a stick which we stake in the ground in the middle of the area chosen, and hang pieces of fish from the end. It’s better, therefore, that the bait is placed above ground level. We want the lizards to go in and out of each of the spaces various times thereby making it more difficult for them to pinpoint exactly where the fish is. For these reasons we decided to make three entrance spaces with a trap in each one. It is important not to put the bait on the ground for two important reasons:ġ – The hermit crabs, mice and even lizards that have escaped the trap will finish off the bait in little time.Ģ – The traps don’t always work when the lizard goes by, be it because it didn’t activate itself or because the cord loop didn’t quite catch any part of the lizard’s body. What is important is to attract the lizards by strong smell as they just adore putrid fish, so the more putrid the bait the farther afield the smell will penetrate. Should we not have caught any fish that day then we can use hermit crabs as they are easy to find around the beach. Once the trap has been built we have to place the bait, this can be the leftover or waste fish from the day. The video explains how the mechanism of this trap works. By doing this we will be forcing it to pass through one of the three spaces where we will have laid our traps. Once the spot has been chosen we go on to gather plants and roots and try to surround a circular space placing the bait in the centre, but always leaving three open spaces where the lizard can get inside. So a place between the jungle and the beach is the best place to lay the trap. However, they invariably go to the beach every day at some time, looking for any dead fish the tide brings in. It has to be as far away from our refuge as possible as these reptiles usually keep as far away from humans as they can. The next step will be to find the right place to set the trap. If there is no thread to hand we can use our footwear, but if we are barefoot then we’ll have to make our own thread with plant fibre (finding that making slip knots won’t be easy). Should we only have one thread then we can only lay one trap. įirst we have to find three fine threads/rope of about 1.5 metres long (one for each trap). In the video below that was taken on one of our desert islands you can see all the process from the begining. In this article I will try to explain how to catch a monitor lizard on a desert island letting us change our diet should we find ourselves abandoned a long time.
0 Comments
Leave a Reply. |